Repa Quick 20

Repa Quick 20

Product Description

Fast-drying filler powder for indoor repairs and filling on plaster, concrete, gypsum boards etc. In dry form, polymer-reinforced plaster is soluble in water.
  • Easy to mix
  • Good filling capacity
  • Doesn't sink


For interior use for repairs on concrete, gypsum board, glass felt etc.


Must be clean, dry, firm and suitable for surface treatment.


Remove loose material and paint by cleaning, sanding and dusting.
Remove dirt, grime, grease and chalking materials by cleaning with Fluren 37.
Water-soluble discolouration, nicotine and soot can be cleaned with Fluren 49.
Sand flat hard, slippery surfaces.
Apply the filler paste and smooth out.
Sand the surface and prime it before any additional treatment.


Apply and smooth out using a filler knife.
Decide your choice of tools based on the size of the surface.
Mixing: 1 part water and 2 parts powder.
Pour water in a bucket and sprinkle in the powder.
Leave for 3-5 minutes before stirring.
Apply a sufficient amount and then work and smooth out the filler paste.
Cold/ heat can affect the viscosity of the material.
Condensation must not occur.
Cold and increased humidity extends drying time, full curing and recoat interval
Increased temperature and low atmospheric humidity reduce drying time and full curing
Always perform a test treatment for a check and acceptance of adhesion and result


Smooth out surface for additional treatment.

Environmental information

Remove as much filler as possible before cleaning with water. Bring remains of fluent paint to the local recycling centre. Minimize your paint waste by pre-estimating how much paint you need. Keep the leftover paint for future use so you can effectively reduce the environmental impact.

Storage: Cool, frost-free, and tightly closed

Protection equipment: Spray painting: painting suit, full face mask with combined filter. Painting: eye protection, gloves. Sanding: respiratory protection.

Technical Data

Plaster & Sealant
Weight %
Volume %
Workable temperature
Min. +10°C
Max. humidity 80 % RH.
Cleaning of Tools etc.

Current TDS Version

október 2020